We often see vehicles covered with various propaganda signs on the road. This is the LED advertising vehicle . Many vehicle owners today do not understand the daily maintenance and maintenance of LED advertising vehicles, which greatly reduces the lifespan of the vehicles. It is easy to cause failures. What are the daily maintenance items for LED advertising vehicles ?

Before the advertisement vehicle is operated, the driver needs to check whether the door of the LED screen box has been fully locked, whether the LED screen has been fully landed, and it is also required to check whether the welding site of the LED screen site plate and the steel plate lifting lug is There is no existence of cracks, tire pressure is not normal and so on. Only after doing these inspections can you begin your daily tasks.

LED advertising vehicles in the process of driving, the speed is best to control within 30 kilometers per hour, and the follow-up staff also need to be on the move every time to monitor the advertising vehicle, found that when the road is uneven, need to be timely Remind the driver to slow down.

In the LED advertising vehicle operation, the middle distance between the tail of the tractor and the front end of the media car can not be less than one meter, otherwise, when turning, the tail of the tractor will damage the outer casing of the media car, and the short distance can be manually moved. Do not use towing traction rods with the tow bar mounted on the truck.

When the advertising vehicle arrives at the designated working site, it is first necessary to put down the four supporting feet of the car and adjust the length and tighten it with the ground. In the case of extremely strong winds, it is necessary to prevent advertisements from being advertised. Can't raise the car's screen. When the advertising vehicle raises the screen, it is forbidden that the worker will put his head into the space below the screen and the gap of the chassis so as to avoid accidental production.

If the LED advertising vehicle malfunctions, professional people are required to perform maintenance. At the same time, the screen needs to be raised after the screen is repaired, and a support rack for preventing sudden drop is also required inside the elevator. Before the start of the LED, the ground needs to be grounded. Wire is connected to prevent leakage.

Injection And Blow Molding Machine

Injection And Blow Molding Machine,Injection Blow Molding Machine,Injection Blowing Machine,Plastic Preform Making Machine

JIANGYIN HENTOL NEW MATERIAL CO.,LIMITED , https://www.hentolgroup.com