The start of the garbage truck is basically the same as that of a normal vehicle. I believe we are all familiar with it. We must insert the key, place it in a spiral, and light up on fire. Is this still necessary for people to teach? Need to know, according to this method in the long run, it will cause difficulties in the start of garbage. It takes a few fires to start.

The correct ignition method for the garbage truck is: insert the key to rotate to ACC stop, wait for 2 to 3 seconds or so, make the main power relay contact firmly contact, let the first part needs to energize the device power; continue to turn the key to ON, and then Stop waiting for 6 to 10 seconds, let the oil pump relay pull, wait for each sensor to adjust the state, turn the key to START until the engine runs continuously and return to ON. However, for temporary or short-term parking, you can start quickly without stopping.

In the SMC-BMC-GMT molding process, the Sheet Molding Compound is placed in a mold which has been heated to a specified temperature, and is pressurized by a hydraulic press to uniformly fill the cavity with the molten sheet molding compound, and then solidified by a pressure holding heat for a period of time. 

SMC/BMC/GMT Molding

SMC Molding,BMC Molding,GMT Molding

CHENGDU ZHENGXI HYDRAULIC EQUIPMENT MANUFACTURING CO., LTD. , http://www.zxhydraulic.com